Building work required prior to the delivery of your spa.
 

Base
A 4-inch concrete base, concrete slabs, or timber deck, level and flat, the size of the spa is recommended.

Power
A single-phase 240-volt power supply with 30mA R.C.D. (E.L.C.B.) fitted at the fuse board.
An isolator minimum 2 metres from the water and a cable run to the back wall of the tub with a 4-metre tail of cable loose, for our installers to connect into the spa control panel. (Located behind the timber access panel). If unsure contact a qualified electrician.

MODEL Minimum Power Ideal Power
2000 and 3000 series 13 Amps 20 Amps
4000 series 20 Amps 30 Amps
Grand canyon 30 Amps 40 Amps
Tango Series
Tango 18 13 Amps 20 Amps
Tango 18 turbo 13 Amps 20 Amps
Tango 26 turbo 20 Amps 30 Amps
Tango 42 turbo 30 Amps 40 Amps
Tango 42 Premier 30 Amps 40 Amps
Platinum Series
Platinum 20 13 Amps 20 Amps
Platinum 40 20 Amps 30 Amps
Platinum 60 30 Amps 40 Amps
Platinum 60 Premier 30 Amps 40 Amps
 

The ideal power rating for cabling should be used if you want to be able to run all the functions of the hottub at once. For example in winter you may wish to run Jets, Pumps, Bubbler and Heater at the same time.

Water
A garden hose is needed to fill the hot tub, preferably off the rising main.
A garden hose is needed for emptying the hot tub, pushed on a spigot and run to a drain.

Access
Sufficient access is required to the site. (Be aware of, doorways, gates, corners, steps, drainpipes, trees, and branches, outside taps, roof eaves, and steep slopes etc.)
Normally we use a dolly to move the spa on its side with 2 men .
So the height of your spa is now the width and the width is now the height.

 

You may need to supply more manpower on the larger models.
If access to the site is not adequate, we can crane it over if necessary. (Charged separately)



If you are unsure about any of the site preparation details given here, call us or ask your electrician.